To Clear The Memory:

1. Press STOP on the remote control twice.

2. Press CLEAR on the remote control until the display shows “0, program, repeat.”

 

To Program The Memory:

 NOTE: The memory has twenty slots for programmed tracks. You may program the tracks in any order and you may program a track to play more than once, but each time a track number is entered into the memory, it fills a memory slot. Only tracks 1-20 will appear in the track grid when programmed; anything above 21 will appear on the left hand side of the display when entered into the memory and will only appear again while that track is playing.

 1. Turn the CD player “ON.”

 2. Make sure “PROGRAM” and “REPEAT” appear on the player’s display.

If they do not appear on the display, press the REPEAT BUTTON and the PROGRAM BUTTON on the remote control to make them appear. Make sure the display shows “REPEAT” and not “REPEAT 1.”

 3. Press the OPEN/CLOSE BUTTON to open the disc tray and insert the disc writing side up in the disc tray and press the OPEN/CLOSE BUTTON to close the disc tray.

 4. Choose the messages and the playing order from your track legend booklet.

 5. Enter your selection by pressing the numbered buttons.

For numbers 1 through 10, just press the numbered 1-10 buttons. For numbers 11 and higher, press the >10 button and then press the appropriate numbered 1-10 buttons. (For example: to enter track 15 press the >10 button, then 1, and then 5.)

 6. Press PLAY.