Using your Track Legend, choose the messages you wish to program.

 1. Turn the CD player “ON.”

 2. Press “OPEN/CLOSE" and insert the compact disk (writing side up) into tray. Press “OPEN/CLOSE".
(To erase the programming, press "STOP" then "CLEAR" until the track list [calendar-like display] is empty.)

 3. Press the OPEN/CLOSE BUTTON to open the disc tray and insert the disc writing side up in the disc tray and press the OPEN/CLOSE BUTTON to close the disc tray.

4. Use the numbered buttons to program tracks.
For numbers 1 through 10, just press the numbered 1-10 buttons. For numbers 11 and higher, press the >10 button and then press the appropriate numbered 1-10 buttons. (For example: to enter track 15 press the >10 button, then 1, and then 5.)

 5. After all selections have been made, verify the "PROGRAM" and "REPEAT" are shown on the display. If the display shows
"REPEAT" or is Blank, press "REPEAT" until "REPEAT" shows on the display.

6. Press "PLAY"

Tips

Check your program order: Press "STOP n." Then press "CHECK." Each time you press Check, the display shows the track
number in the order you programmed it. After the last track is shown, the display will read "END."

Add or remove tracks from your program: The best way to add or remove tracks is by reprogramming your player. If tracks
are added or removed without reprogramming your player, it will return to your original program in the event of a power outage.

NOTE: In case of power failure, or if player is turned off, original tracks will be installed when player is powered up again.

To erase original tracks memory: Press "STOP" twice and re-enter complete sequence.